Fluorine plastic slitting machine frequently asked questions and answers:
1) What should I do if there is a beating phenomenon in the reel?
The solution for recycling fluoroplastics manufacturers is to adjust the three-point centering bearing to contact the unwinding shaft at the same time.
2) What if the main motor does not turn?
Recycling fluoroplasticsThe manufacturer's solutions include: resetting the emergency stop button, connecting the three-phase power supply, checking the loose contact of the main circuit, repairing or replacing the variable frequency start button switch.
3) What if the automatic correction power indicator does not light up and the indicator does not light up?
The solution for recycling fluorine plastic manufacturers is: replace 1a fuse core.
4) No automatic correction, manual automatic no action how to do?
The solutions of fluorine plastic recycling manufacturers are: replace the 5a fuse core, and refer to the instructions for automatic correction.
5) How to correct deviation?
The solutions of recycling fluoroplastics manufacturers are as follows: refer to the instructions for automatic correction and provide unwinding fluoroplastics according to the requirements for correction.
6) What if slitting and winding are not complete?
The solutions of fluoroplastic recycling manufacturers are: replacing the paper core with the required inner diameter, and using the winding roller in the winding process.
7) What if the ear material fan does not turn?
The solutions of fluorine plastic recycling manufacturers are: reset the thermal relay to restart and restore the three-phase power supply 380v.
8) What about the trend of unwinding fluoroplastics?
The solutions of recycled fluoroplastics manufacturers are: adjusting the appropriate unwinding tension, and if high-quality slitting is required, the requirements for the slitting material itself will be correspondingly high.
9) What about the trend of slitting and winding fluoroplastics?
The solutions of fluoroplastic recycling manufacturers include: adjusting the appropriate winding tension, using a pressing roller for winding and wrapping the slitting material through the pressing roller before entering the winding paper core.
10) What if the meter count is not allowed?
The solution of the recycling fluoroplastic manufacturer is as follows: contact the two wheels of the rice counting wheel with the feeding rubber roller at the same time, make a mark on the rice counting wheel and shake it for 5 turns to count 1 meter, otherwise replace the rice counting device.
11) What if the tension is unstable and cannot reach the required tension?
The solutions of recycled fluoroplastic manufacturers include: eliminating mechanical faults, adding 5g of new magnetic powder to the brake or clutch when confirming that the tension current is large and the tension cannot be reached.
12) no tension how to do?
The solutions of recycled fluoroplastic manufacturers include: placing the tension switch in the "on" position, adjusting the tension to rotate to the appropriate position, adjusting the proximity switch and detection block to 2-3<>mm, replacing the magnetic powder power amplifier, replacing the magnetic powder brake or clutch, re-connecting the disconnection and replacing the proximity switch.
This article comes from:www.tflpfa.com
Popular Articles:Application and Performance Advantages of PTFE Gasket